Removing The Carry Bag; Installing Shoulder Straps - Invacare Platinum Mobil User Manual

5. Lay the concentrator and carry bag down with air intake filter
screen facing upward.
6. Push the concentrator into the carry bag until it is fully seated
against the top retainer.
7. Rotate the base of the carry bag onto the bottom of the
concentrator and fully zip up the bottom of the carry bag.
8. Return the concentrator and carry bag to the upright position.
9. Check that the cutouts in the top retainer are correctly aligned
with the oxygen outlet port and external power input connector.
If not aligned, remove the carry bag and reinstall as described in
steps 1–9.

3.4.2 Removing the Carry Bag

1. Ensure the concentrator is off and disconnected from external
power and cannula.
2. Lay the concentrator on a flat surface with the air intake filter
screen facing upward and fully unzip the base.
3. Rotate the base of the carry bag off the bottom of the
concentrator.
4. From the bottom, pull the concentrator out of the carry bag. If
needed, the top surface of the concentrator can be pushed to
help remove it from the bottom of the carry bag.
5. Return the concentrator to the upright position.
6. Fully zip up the bottom of the carry bag.
1194969-A-00

3.4.3 Installing Shoulder Straps

The carry bag can be configured as a messenger bag using
one shoulder strap or as a back pack using two shoulder
straps.
Messenger Bag Configuration
Using a single shoulder strap A, attach a clip B from each end of
1.
the strap to rings C at the top of the carry bag D.
2. Adjust shoulder strap to desired length.
Slide pad Eon shoulder strap to the desired location.
3.
Setup
29