Section 12-Seat; Removing/Installing The Seat Assembly; Removing; Installing - Invacare Pronto M71 Owner's Operator And Maintenance Manual

Hide thumbs Also See for Pronto M71:

Table of Contents

SECTION 12—SEAT

After ANY adjustments, repair or service and before use, make sure that all

attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service, verify that On/Off

switch on the joystick is in the Off position.

NOTE: For this procedure, refer to FIGURE 12.1.

NOTE: This procedure is for wheelchairs WITHOUT the Formula PTO Plus seating system

installed ONLY. For wheelchairs with the Formula PTO Plus seating system, refer to Tilting the

Seat Assembly on page 45.

1. Disconnect the joystick cable at rear of seat. Refer to Disconnecting/Connecting the

Joysticks on page 42.

2. Push down on the latch bar underneath front of seat.

3. Rotate seat assembly backward.

4. Slide the seat assembly forward to disengage seat from pivot brackets located in the rear.

1. Position the seat in the rear pivot brackets as shown in FIGURE 12.1.

2. Rotate seat assembly forward.

3. When seat is lowered, engage seat brackets into seat clevis pins.

When reinstalling the seat verify that the seat brackets are engaged with the seat

clevis pins by pulling up on the latch bar.

4. Pull up on latch bar to verify that brackets are engaged with seat clevis pins.

Pronto® M71™Base with SureStep®

WARNING

Part No 1143240

Table of Contents

Troubleshooting