Setup; Unpacking; Inspection; Powering The Oxygen Concentrator - Invacare Platinum Mobil User Manual

3 Setup

3.1 Unpacking

1. Check for any obvious damage to the carton or its contents. If
damage is evident, notify the carrier or your local dealer.
2. Remove all loose packing from the carton.
3. Carefully remove all the components from the cartons. The
Invacare concentrator's packaging contains the following items
(as shown below) in addition to this user manual. If any parts are
missing, please contact your equipment provider.
•
Concentrator (Model POC1–100B) with carry bag (Model
POC1–150) installed
•
Cannula (Westmed #0194)
•
Two shoulder straps (Part Number 1187483)
•
Battery (Model POC1–110)
•
AC power adapter (Part Number 1187452)
•
AC power cord (Part Number 1187454 for model
POC1–100B)
•
DC power cable (Model POC1–140)
Retain all containers and packing materials for storage or
return shipment.

3.2 Inspection

Inspect/examine exterior of the oxygen concentrator and accessories
for damage. Inspect all components. If damage is found, DO NOT
use concentrator. Contact your provider for service and/or repair or
for assistance with the setup procedure and to report unexpected
operation or events.
1194969-A-00

3.3 Powering the Oxygen Concentrator

WARNING!
Risk of Injury or Damage
To avoid injury and damage that will void the warranty:
– Use only Invacare specified power supplies with the
oxygen concentrator.
– Prior to using the DC power cable, the automobile
(boat, motor home, etc.) engine should be running
in order to either operate or charge the oxygen
concentrator.
IMPORTANT
The concentrator will not turn on unless the battery is
charged.
– Connect AC power to the concentrator and allow
battery to fully charge prior to first use.
The oxygen concentrator allows the freedom to choose from the
following power sources to enable use both inside and outside of
the home:
•
Rechargeable battery(s)
•
AC power outlet
•
12 volt DC power cable

3.3.1 Installing the Battery(s)

DANGER!
Risk of Death, Injury or Damage
To avoid death, injury or damage from fire:
– DO NOT heat above 140°F (60°C), incinerate,
disassemble, or short terminals.
– Dispose in accordance with all local regulations.
Setup
23