Initial Setup - EverFocus EPTZ9200 Series Quick Installation Manual

EPTZ9200/9300 Series

Initial Setup

To allow the control device, such as a keyboard, to recognize and then control multiple cameras, you need
to set up the ID address for the cameras using the DIP switch on the Camera Main Body. You can also set up
the Protocol, Baud Rate and Video Output Format for the cameras.
Note: Please ensure to turn off the power when setting up the DIP Switch. The new values will only take
effect after restarting the camera.
Camera Main Body
DIP Switch
ID Address
The ID address of the camera should be set to correspond properly with the control device, such as a
keyboard. The eight switches on the right correspond with the binary code of the ID address, allowing up to
256 ID addresses (0 ~ 255) to be set up. Please refer to the sticker on the camera main body or the
following diagram for setting up the ID address. The default ID address is 1.
Sticker on the Camera Main Body DIP Switch
6