EverFocus EPTZ9200 Series Quick Installation Manual page 10

Protocol
The first, second and the third switches on the left are used to set the communication protocol. Please
refer to the sticker on the camera main body for setting up the protocol. The supported protocols are listed
on the sticker. The default protocol is EVF.
Sticker on the Camera Main Body
Note: If you switch the three protocol switches to ON, the camera will enter a self-test mode.
Baud Rate
The fourth and fifth switches on the left are used to set the baud rate (transmission speed). Please refer to
the sticker on the camera main body for setting up the baud rate. The default baud rate is 9600.
Sticker on the Camera Main Body
Video Output Format
The sixth and seventh switches on the left are used to set the video output format. Please refer to the
sticker on the camera main body for setting up the video output format. The default video output format is
by OSD (OFF/OFF).
Sticker on the Camera Main Body
DIP Switch
DIP Switch
DIP Switch
9
EPTZ9200/9300 Series