Setting A Pump Up (Reservoir) Group - Siemens SITRANS LUT400 Operating Instructions Manual

Setting a pump up (reservoir) group

Sets a group of two pumps to pump up a reservoir.
SITRANS LUT400
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aa
Setpoint sample values:
(see tables below)
Set the common parameters
Prerequisite: Substitute the details of your application in place of the sample values
provided. If you are bench testing the device, set your test values to be the same as the
sample values.
2. 1 .2. Sensor Mode
Response Rate
2. 1 .6. Transducer
2. 1 . 1 . Units
2.2.1. Low Calibration Point
2.2.2. High Calibration Point
Set Relays to ALTERNATE DUTY ASSIST (ADA)
Parameter
2.7.1.4. Pump Control Mode
or
2.7.1.5. Pump Control Mode
A5E33329501
S T A S U 4
inflow
* ON Setpoint Pump 1 / Pump 2
** OFF Setpoint Pump 1 / Pump 2
Parameter
2.1.3. Sensor Mode
or
Value Description
ADA
SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
**
level
*
aaaaaaaaaaaaaa
aaaaaaaaaaaaa
aaaaaaa a
Sample Value
Sets the control algorithm used to trip the pump
relay to ALTERNATE DUTY ASSIST.
sensor ref. point
High Cal. Pt.
Low Cal. Pt.
outflow
Level
Medium
XPS-10
M
1.8
0.4
Page 85