Setup - Siemens SITRANS LUT400 Operating Instructions Manual

1.1. Quick Start
1.1.1. QS Level
1.1.2. QS Volume
1.1.3. QS Flow
Available only on LUT430 (Pump and Flow), and LUT440 (OCM) configured
models.
1.2. Pump Control

2. Setup

Notes:
Local Commissioning
• See
page 127 for instructions.
• Default settings in the parameter tables are indicated with an asterisk (*) unless
explicitly stated.
• Values shown in the following tables can be entered via the local push buttons.
2.1. Sensor
2.1.1. Units
Determines sensor measurement units used when 2.1.2.Sensor Mode set to
Level, Space, Distance, or Head.
Options
2.1.2. Sensor Mode
Menu number
OR
2.1.3. Sensor Mode
Menu number
(OCM model).
Sets the type of measurement required for the application.
Options (Mode)
*
a.
Option available only on LUT430, LUT440.
Page 138 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
on page 33 or
M, CM, MM, FT, IN
Default: M
2.1.2.
visible on LUT420 (Level model).
2.1.3.
visible on LUT430 (Pump and Flow model), and LUT440
Description
LEVEL
Distance to material surface
SPACE
DISTANCE
Volume of material in volumetric
VOLUME
units (based on level)
a
Distance to material surface
HEAD
Flowrate in an open channel in
a
FLOW
Flowrate Units
Operation via SIMATIC PDM 6 (HART)
Reference point
Low Calibration Point
(process empty level)
High Calibration Point
(process full level)
Sensor Reference Point
Low Calibration Point
Zero Head
Zero Head (zero flow level)
on
A5E33329501