Siemens SITRANS LUT400 Operating Instructions Manual page 121

Round Pipe
Diagonal View
* This dimension should be at least 15 cm (6") shorter than the blanking value (see
Range
).
** The transducer must be above the maximum head by at least the blanking value.
Parameter
2. 1 5.1. Primary Measuring Device (PMD)
2. 1 5.4. PMD Dimensions
2. 1 5.3.3. Maximum Head
2.2.5. Far Range
2. 1 5.3.7. Flowrate Units
2. 1 5.3. 1 . Method of Flow Calculation
2. 1 5.3.4. Maximum Flow at 20 mA
A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
transducer
*
**
h
D
Value
Round Pipe
Pipe Inside Diameter D
Slope (fall/run) s
Roughness Coefficient n
2.2.4. Near
Page 113