Properties Of The "Nc Part Program" Display Object - Siemens sinumerik 840d sl Configuration Manual
Sinumerik integrate create myhmi / wincc v13 sp1
Hide thumbs
Also See for sinumerik 840d sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Configuring screen objects
8.3 Properties of the "NC part program" display object
8.3
Properties of the "NC part program" display object
Introduction
You have several ways of configuring the "NC subprogram" display object in the "Screens"
editor. These selection options are available for a selected display object in the Inspector
window below Properties.
Figure 8-2
116
Properties of the "NC subprogram" display object
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014
Advertisement
Table of Contents
