Dodge RAM 1500 1998 Owner's Manual page 2234

DR
TRANSFER CASE - NV244 GENII (Continued)
Fig. 65 Install Front Output Shaft Seal Slinger
1 - SEAL SLINGER
2 - INSTALLER 8840
(6) Install the new front output shaft seal slinger
(Fig. 65) with Installer 8840. Install the slinger onto
the shaft until the tool contacts the front of the out-
put shaft.
Fig. 66 Install Drive Sprockets and Chain
1 - FRONT DRIVE SPROCKET
2 - DRIVE CHAIN
3 - REAR DRIVE SPROCKET
(7) Install the front sprocket, rear sprocket, and
chain as an assembly.
(8) Lower the front sprocket, rear sprocket, and
chain over the front and rear output shafts simulta-
neously (Fig. 66) until fully seated on both splines.
TRANSFER CASE - NV244 GENII
Fig. 67 Install Rear Output Shaft Retaining Ring
1 - REAR OUTPUT SHAFT
2 - RETAINING RING
(9) Install the rear output shaft retaining ring
(Fig. 67) onto the output shaft.
Fig. 68 Installing Front Sprocket Retaining Ring
1 - FRONT SPROCKET
2 - RETAINING RING
3 - FRONT OUTPUT SHAFT
(10) Install the front sprocket retaining ring (Fig.
68).
21 - 531