Dodge RAM 1500 1998 Owner's Manual page 2340

DR
REAR FENDER (Continued)
Fig. 23 TAIL LAMP OPENING
1 - TAIL LAMP OPENING
2 - FENDER NUTS (2)
Fig. 24 LOWER REAR FASTENERS
1 - REAR FENDER NUTS (2)
2 - PICK-UP BOX INNER PANEL
(1) Carefully position the fender over the support
brackets.
(2) Install the four inner nuts along the front edge
of the fender and tighten to 7 N·m (60 in. lbs.).
Fig. 25 LOWER FRONT FASTENERS
1 - PICK-UP BOX INNER PANEL
2 - FRONT FENDER NUTS (4)
Fig. 26 SUPPORT BRACKET
1 - FENDER SUPPORT BRACKET (2)
2 - PICK-UP BOX
3 - BOLTS (3 PER BRACKET)
(3) Install the two inner nuts along the rear edge
of the fender below the tail lamp unit and tighten to
7 N·m (60 in. lbs.).
(4) Tighten the six support bracket bolts and
tighten to 11 N·m (8 ft. lbs.).
(5) Install the bolts along lower edge of the fender
and tighten to 7 N·m (60 in. lbs.).
(6) Connect the marker lamps electrical connec-
tors.
(7) Install the wheelhouse splash shield. (Refer to
23 - BODY/EXTERIOR/REAR
SPLASH SHIELD - INSTALLATION)
(8) Install the two nuts from within the tail lamp
opening and tighten to 7 N·m (60 in. lbs.).
(9) Install the tail lamp unit. (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION)
EXTERIOR 23 - 45
WHEELHOUSE
- EXTERIOR/TAIL