Dodge RAM 1500 1998 Owner's Manual page 2077

21 - 374 AUTOMATIC TRANSMISSION - 45RFE/545RFE
INPUT CLUTCH ASSEMBLY (Continued)
1 - BEARING NUMBER 3
2 - OD HUB/SHAFT
3 - SNAP-RING (WAVE)
4 - REV/OD REACTION PLATE
5 - BEARING NUMBER 4
6 - SNAP-RING (FLAT)
7 - REVERSE HUB/SHAFT
8 - REVERSE CLUTCH
9 - REVERSE REACTION PLATE
OVERDRIVE CLUTCH
The overdrive clutch is hydraulically applied in
third (direct), fourth, and fifth gears by pressurized
fluid against the overdrive/reverse piston. When the
overdrive clutch is applied, the overdrive hub drives
the reverse carrier/input annulus assembly.
REVERSE CLUTCH
The reverse clutch is hydraulically applied in
reverse gear by pressurized fluid against the over-
drive/reverse piston. When the reverse clutch is
applied, the reaction annulus gear is driven.
Fig. 78 Input Clutch Assembly - Part 2
10 - SNAP-RING (SELECT)
11 - PLATE
12 - DISC
13 - OD CLUTCH
14 - SNAP-RING (TAPERED)
15 - UD/OD REACTION PLATE
16 - SNAP-RING (FLAT)
17 - UD HUB/SHAFT
18 - BEARING NUMBER 2
DISASSEMBLY
snap-ring from the input clutch retainer (Fig. 79).
input clutch retainer.
pack from the input clutch retainer.
drive hub.
clutch retainer (Fig. 79).
(1) Remove the reverse reaction plate selective
(2) Remove the reverse reaction plate from the
(3) Remove the reverse hub and reverse clutch
(4) Remove the number 4 bearing from the over-
(5) Remove the overdrive hub from the input
DR