Camera: Ptz - Creating A Patrol - Swann PRO-SERIES HD Instruction Manual

Camera: PTZ - Creating a Patrol

When creating multiple Patrol groups (group 1 is the default), click the
Patrol dialogue box and change accordingly. Up to 4 different Patrol
groups can be created.
1.
Click the "Set" button to create a Patrol.
2.
Select a Preset position that you would like to add to the Patrol. The
Preset position will determine the order at which the camera will cycle
through the Patrol.
3.
The Duration refers to the time span (in seconds) the camera will stay
at the corresponding Preset position. Change accordingly.
4. This defines the speed at which the camera will move from one Pre-
set position to the next.
Add:
Click this button to add your Preset position to the Patrol. The Key-
26-05-2015 9:30:15 Tue
1
Camera 01
Patrol mode automatically
moves the camera using the
Preset positions created.
Point will increase each time you add a Preset position.
OK: Click this button to finish.
Cancel:
Click this button to cancel.
Clear:
Click this button to delete the selected Patrol group.
Clear All: Click this button to delete all Patrol groups.
PTZ: Click this button to access the full PTZ controls available. Click
the triangle button until you reach the "General" menu. Select a Patrol
group then click "Call Patrol" to start. The camera will move to the first
Preset position and then move to the subsequent positions. Click "Stop
Patrol" to stop.
Click the "X" button to close the PTZ controls when finished.
• Click the "Back" button to go back to the Menu.
2
3
4
20