Wds Ap - Planet WNAP-6325 User Manual

 Disable SSID Broadcasting
Enable Isolated
Lock to AP MAC
Radio Mode
 Data Rate
 Security Setting
 Transmit Power
 Transmit Distance
 TDMA
 Advanced Settings
 Access Control

5.1.3 WDS AP

Click "Operation Mode"  "WDS AP" and the following page will be displayed. This section allows you to
configure the WDS AP mode. For each wireless parameter, please refer to section 5.1.1 AP for more
information.
Check it to disable SSID broadcasting.
Check it to isolate each connected wireless clients so that they
cannot access each other.
Enter the Mac address of the remote AP.
Select the channel width to "Auto Select", "2G 11NG HT20" or
"2G 11NG HT40"
Select MCS0~15 or Auto from the pull-down menu. The default
is "Auto".
Press "Setup" for more configurations. Please refer to 5.1.7
Security Setting for more information.
The range of Transmit power is "12~27 dbm". In case of
shortening the distance and the coverage of the wireless
network, input a smaller value to reduce the radio transmission
power.
Select a specified distance of the two nodes.
Displays the System Time.
Press "Setup" for more configurations. Please refer to 5.1.8
Advanced Settings for more information.
Press "Setup" for more configurations. Please refer to 5.1.9
Access Control for more information.
-31-
User Manual of WNAP-6325