Juniper mesa 2 Owner's Manual page 50

6. The Mesa 2 charges more quickly if the power settings
are set up to allow the Mesa 2 to enter a low power
mode when it is not in use, but is plugged in. To adjust
this setting, go to the Start menu, then Settings > System
> Power & sleep.
7. To remove the Mesa 2 from the dock, press on the
release button and pull the Mesa 2 up.
Adding a Video Monitor or Projector
To connect to a video monitor to the Mesa 2, plug the
device into the HDMI port (directly or through a USB to HDMI
dongle). Go to the Action Center and select Project, then
Extend or the option that you prefer. You can have the
start bar appear on either one or both displays, or set the
external monitor to be the main display. This can be helpful
in an office environment. To set up additional features like
orientation, go to the Start menu, then Settings > System >
Display.
Mounting the Dock to a Surface
The Office Docking Station is freestanding. It can also be
mounted to a surface like a desk or shelf. There are keyhole
slots on the bottom for this purpose. The spacing between
the holes is 4" (101.5 mm).
Ethernet Specifications
10/100/1000 Mbps twisted-pair Ethernet
„
IEEE802.3/802.3u/802.3ab 10BASE-T, 100BASE-TX, and
„
1000BASE-T
Manages twisted pair crossover detection and correction
„
Full-duplex and half-duplex capability (only full-duplex
„
operation at 1000 Mbps)
46
Mesa 2 Rugged Tablet Owner's Manual