Juniper mesa 2 Owner's Manual page 34

Cellular. Tap on the Cellular icon, then select Advanced
Options. The IMEI number is listed under Properties.
Install the SIM Card
The card slot and flexible card holder are designed to
hold the card securely in place so it will not come out or
disconnect if the tablet is dropped. To insert or remove a
card, follow these steps:
1. You must power off the tablet.
2. Remove the battery door as outlined in chapter 1.
!
CAUTION: The Mesa 2 is not sealed against water and
dust when the battery door is not installed properly.
3. Remove the battery pack by pulling up on the black tab
on the front of the battery pack.
4. An image on the battery compartment label shows the
correct location and orientation for the SIM card (slot
on the left). Pull the flexible card holder back out of the
way. Push the card into the slot to insert it.
5. Push the flexible card holder back into place, covering
the card slots.
6. Replace the battery pack, and attach the battery door.
To remove the SIM card, gently pull it out with tweezers or a
piece of tape.
Note: If the modem was on before shutting the Mesa 2
down to insert the SIM card, you are prompted to configure
the data connection when you reboot.
30
Mesa 2 Rugged Tablet Owner's Manual