Protecting The Touchscreen; Recycling The Mesa 2 And Batteries - Juniper mesa 2 Owner's Manual

Protecting the Touchscreen

Protect the touchscreen from impact, pressure, or abrasive
substances that could damage it. To further protect the
touchscreen, apply a screen protector (optional accessory)
using the directions that come with it in the package.
!
CAUTION: Be sure to replace the screen protector as often
as the screen protector instructions recommend.
Cleaning the Mesa 2
Make sure the battery door is securely installed. Remove
the screen protector if you want to clean underneath it.
Use warm water, a mild cleaning solution, and a soft bristle
brush to gently clean the Mesa 2.
!
CAUTION: Do not direct a high-pressure stream of water
at the device to clean it. This action could break the seal,
causing water to get inside the device and voiding the
warranty.
!
CAUTION: Exposure to some cleaning solutions may
damage your device, including automotive brake cleaner,
isopropyl alcohol, carburetor cleaner, and similar solutions.
If you are uncertain about the strength or effect of a
cleaner, apply a small amount to a less visible location as a
test. If any visual change becomes apparent, promptly rinse
and wash with a known mild cleaning solution or with water.

Recycling the Mesa 2 and Batteries

When the Mesa 2 reaches the end of its life, it must not be
disposed of with municipal waste. It is your responsibility
to dispose of your waste equipment by handing it over to
a designated collection point for the recycling of waste
electrical and electronic equipment.
The Li-Ion battery packs for your Mesa 2 are recyclable.
Avoid placing them in the trash or municipal waste system.
To find the nearest battery recycling center in the USA,
you can contact the Rechargeable Battery Recycling
Corporation's at 1-877-723-1297.
Appendix A Storage, Maintenance, and Recycling
51