Sensors - Juniper mesa 2 Owner's Manual

Mesa 2 is Locked Up
If the Mesa 2 is completely stuck and won't respond or you
cannot get to the Start menu, hold the power key down for
five seconds to see if that solves it. If that doesn't work, hold
it down for 10 seconds. This causes a hardware shut off. Press
the power button again to power it on.
If 10 seconds doesn't work, hold the power button down for
20 seconds. Batteries are forced to electrically disconnect
from the tablet, causing a complete shut down. The tablet
cannot be powered on again until it is plugged in with the
AC wall charger. Keep this in mind if you are in the field.
!
CAUTION: Holding the power button down for 20 seconds
for a forced disconnect is recommended only as a last
resort. It can be very hard on the system hardware. NEVER
do this to power off or reset a Mesa 2.
Recovery Image
You can restore the Mesa 2 back to the factory defaults
using the Recovery Image.
Before initiating a recovery, make sure that the tablet is
plugged in. Go to the Start Menu and select Settings >
Update & Security > Recovery > Reset This PC > Get Started.
Choose Keep my files or Remove everything depending on
your personal needs. A verification screen asks you to verify
what you want to do with the existing files. The recovery
process can take up to 3 hours.

Sensors

Compass, Accelerometer, and Gyroscope
The Mesa 2 has a built-in compass and accelerometer.
The accelerometer assists the compass in determining
direction, even when the device is not resting flat. The
gyroscope senses change in angular motion. The compass,
accelerometer, and gyroscope can also be used by other
user applications.
The sensors in the Mesa 2 have been factory calibrated.
Periodic user calibrations helps the compass be calibrated
to the environment it is being used in. Move the device
through all orientations and angles.
22
Mesa 2 Rugged Tablet Owner's Manual