Juniper mesa 2 Owner's Manual page 11

Attach the Hand Strap and Stylus Tether
A hand strap, fine tip capacitive stylus, and tether are
included with the Mesa 2.
To attach the hand strap and tether to the Mesa 2, follow
the diagrams below. You can attach them to the right or left
side of the tablet:
1
1. Attach one end of the stylus tether to the stylus. To
attach the tether to the tablet, follow these steps:
2. Push the free tether loop through one of the tether
attachment points located on the side of any of the four
corners.
3. Insert the stylus with the attached tether through this
loop and tighten the loop.
2
3
Chapter 1 Contents
7