Led Activity Indicators - Juniper mesa 2 Owner's Manual

Removing the Replaceable Battery
To remove the replaceable battery to replace it or to insert
or remove SD cards, follow these steps.
1. Power off the tablet.
2. To remove the battery compartment door, push the
battery lock switch in, slide it to the unlocked position,
and remove the door.
!
CAUTION: The Mesa 2 is not sealed against water and
dust when the battery pack and battery door are not
installed properly.
!
CAUTION: Always power off the tablet before removing
the battery. Failure to do so may cause loss of data or
damage to the tablet. EXCEPTION: If your tablet has an
internal battery, this caution does not apply. You can
safely remove the removable battery while the unit is
running.
3. Remove the battery pack by pulling up on the black tab
on the battery pack.
Note: Some models are equipped with a battery
retention clip which can make removal of the battery
more difficult. The flat end of the captive stylus can be
used as a lever to remove the battery pack.

LED Activity Indicators

LED activity indicators are located on the front of the Mesa
2 in the upper-left corner.
Red LED, solid: 1) When the Mesa 2 is put to sleep or
„
powered off by pressing the power key
16
Mesa 2 Rugged Tablet Owner's Manual
, the red LED is