Cables Required - Paradyne IP DSLAM BitStorm 2600 Installation Manual

Cables Required

2600-A2-GN20-40
Table 1-1 shows all the cables that may be required for your installation.
Table 1-1. Cable Descriptions
Connector Name Connector and Cable
DSL PORTS 1–24 50-pin RJ21X Telco-type
straight connector and 50-wire
cable. Two cables required, one
for DSL and one for POTS (if
POTS 1–24
used).
Port 3 SFP Transceiver
GigE
Port 3 8-position modular plug and
1000BT 8-wire Category 5 or better
unshielded twisted pair (UTP)
cable.
Port 2 10/100BT 8-position modular plug and
8-wire Category 5 or better
unshielded twisted pair (UTP)
cable.
Port 1 10/100BT 8-position modular plug and
8-wire Category 5 or better
unshielded twisted pair (UTP)
cable.
T1/E1 Ports 1–8 From one to eight 8-position
modular plug and 8-wire
Category 5 or better unshielded
twisted pair (UTP) cables.
CONSOLE DB9 plug connector and
shielded cable.
The other connector
depends on the serial port on
your terminal or PC, but
normally is a DB9 socket.
The other connector
depends on the serial port on
your modem, but normally is
a DB25 plug. A null modem
(crossover) cable is required.
ALARM 5-position terminal block and
shielded, twisted-pair cable.
March 2005
1. Installation
For Connecting . . .
Up to 24 DSL ports to Main
Distribution Frame, punchdown
block, or splitters.
Up to 24 POTS splitter ports to
Main Distribution Frame or
punchdown block.
An upstream BitStorm 2600 to a
downstream BitStorm 2600, or a
downstream BitStorm 2600 to an
upstream BitStorm 2600 or
network.
A Network Management System
(NMS) over a Local Area
Network (LAN) employing
10BaseT or 100BaseT.
A BitStorm 2600 to a T1/E1
bridged PPP or MLPPP uplink
interface.
The BitStorm 2600 to one of the
following:
A terminal or a PC with a
terminal emulation program,
or
A modem.
The BitStorm 2600 to an alarm
system.
1-3