Copy Manager Commands - HP StorageWorks M2402 User Manual

Controller LUN Commands

Copy Manager Commands

To access Copy Manager or other general management features, the commands
must be sent to the router controller LUNs.
The following controller LUN commands can be used for Copy Manager on the
router:
Each of these commands is discussed in the following paragraphs.
Extended Copy Command
The router supports Extended Copy commands in the following two formats:
To initiate Extended Copy operations, the commands can be sent to any tape
device LUN attached to the router. Multiple concurrent Extended Copy
commands can be active.
Version 99-143r1
The Extended Copy command supports the following Target descriptor codes
listed in T10 document 99-143r1 (Page 3, Table 10):
Table 12: Extended Copy Target descriptor codes, version 99-143r1
Fibre Channel World Wide Name Target
Descriptor
Fibre Channel N_Port Target descriptor
The Extended Copy command supports the following Initiator descriptor
codes listed in T10 document 99-143r1 (Page 3, Table 10):
216
Extended Copy
Receive Copy Results
Mode Sense (6) and Mode Sense (10)
Version 99-143r1
Version SPC-2
Item Value
0xE0
0xE1
Network Storage Router M2402 User Guide