Telnet Ui Access - HP StorageWorks M2402 User Manual

Telnet UI Access

To open a Telnet session, the IP address of the router and a Telnet client utility are
required.
Note:
factory settings, the Ethernet port will have to be re-configured using the serial interface.
From most Windows 9x, Windows NT, and Windows 2000 systems, a Telnet
session can be started from the Command (DOS) shell using the following steps:
1. From the Windows Start menu, open the Command Prompt (DOS) window.
2. At the '>' prompt, enter:
3. Enter the user name and password.
4. The Configuration Menu is displayed.
Network Storage Router M2402 User Guide
After each reboot, a new Telnet session must be started. If router is reset to
> TELNET <IP ADDRESS>
where <
IP ADDRESS
The default user name is
HP recommends that the user name and password be changed from the default
values.
> is the IP address of the router
and the default password is
root
Serial/Telnet User Interface
.
password
119