Connecting Hardwired Devices - Interlogix XTI-5 Installation Manual

Figure 4: Mounting holes
7. Secure the mounting screws (provided) to the locations on the wall marked in
step 6. Do not tighten the screws. Leave enough clearance to mount the
mounting plate.
Note: Use wall anchors if no studs are present.
8. Mount the mounting plate to the wall. Insert the top mounting hole first, then
the bottom hole. Adjust the fit to make sure the mounting plate is level. Hold
the mounting plate in place and tighten the screws.
9. Hang the panel chassis on the mounting plate at the plastic hinges, swing the
chassis up to the mounting plate and engage at the tabs (A in Figure 3).
10. Insert the two supplied screws through the tabs (A in Figure 3) to secure the
mounting plate to the panel chassis. Tighten the screws.
11. Reattach the trim ring.

Connecting hardwired devices

The panel has five screw terminals, two battery terminals, and two telephone
connections. The screw terminals connect the AC power, sirens, and/or
hardwired detectors.
Contents Simon XTi-5 Installation Manual 15