Interlogix XTI-5 Installation Manual page 31

Item Description
Speaker Provides voice output and sounds key beeps. The panel speaks arming level
change, system status, and voice chime sensor trips. The panel voice is also
used for voice reporting and remote phone control.
To access the emergency screen and select the appropriate icon (Panic, Police,
or Fire), press EMERGENCY in the top left corner of the touch screen.
Time The current system time.
Depicts the status of the AC and battery. A green power cord icon represents
AC power to the system. A red battery icon represents low battery power to the
system. A green battery icon represents full battery power to the system.
This will appear on the home screen in the event of an alarm. Messages will
also display on this icon describing what caused the alarm. Press this icon to
cancel the alarm.
These four icons depict the status of the sensors installed in your system.
•
A green check indicates sensors are closed or no recent activity detected.
•
A red exclamation indicates sensors are open or recent activity has been
detected.
•
If the icon shows N/A, your system is not configured to support that type of
sensor.
Pressing these icons will open a new screen to provide more detail.
Press this icon to access the Arming Screen.
One of these icons will display depending on your arming level. Press to turn off
intrusion/burglary protection for your system. Only intrusion/burglary sensors are
disarmed. Environmental sensors, such as smoke and carbon monoxide
detectors, stay active at all times Enter your code in the keypad screen that
appears. If you enter an incorrect code, press the Clear icon and enter the
correct code.
Note: In certain configurations with third party modems, the Motion Only Arming
icon may not be shown.
Press to access the Status & Settings screen.
To enter the Status & Settings screen, press the
corner of the touch screen.
Press the Close icon to exit a menu or option edit mode and navigate up one
level. Pressing the Close icon while in the top menu level exits the system menu
level. The panel automatically exits the system menu after a few seconds of
inactivity if no access code has been entered yet. After an access code has been
entered to access a code-protected area of the system menu, the timeout is four
minutes.
Contents Simon XTi-5 Installation Manual
icon in the bottom right
25