Installing And Removing Dedicated Stack Cables; Introduction - H3C S5100-SI series Quick Start Manual

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
Note:
Keep the removed small cover plate properly for future use.
When tightening the fastening screws at both sides of the optional
module with a screwdriver or an electric screwdriver, make sure
that the torque is not bigger than 0.4N•m.
Hot swapping of XENPAK optical modules is supported.
III. Removal
Step 1: Put on an ESD-preventive wrist strap and verify the
ESD-preventive wrist strap properly grounded.
Step 2: Loosen the fastening screws at both sides of the XENPAK
optical module using a flathead screwdriver.
Step 3: Pull the XENPAK optical module towards you, until it
completely comes out of the switch chassis.
3.8 Installing and Removing Dedicated Stack
Cables

3.8.1 Introduction

In a stack of the S5100-EI series switches, dedicated stack
cables are needed to connect the 10GE stack ports of the switches.
Figure 3-38 Schematic diagram of a dedicated stack cable
Chapter 3 Installing the Switch
3-42