H3C S5100-SI series Quick Start Manual page 46

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
4) Hold the two sides of the switch and slide it gently along the
guide rails into the cabinet until it is located in a proper
position, as shown in Figure 3-13. Ensure that the bottom
side of the guide rails and the switch are in close contact.
Figure 3-13 Install front mounting ears and guide rails
5) Fix the other end of front mounting ears to the front brackets
of the cabinet with M6 screws and captive nuts and ensure
that the front mounting ears and guide rails have fixed the
switch in the cabinet securely, as shown in Figure 3-14.
Chapter 3 Installing the Switch
3-15
Front panel