H3C S5100-SI series Quick Start Manual page 67

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
Step 2: Loosen the mounting screws of the filler panel on the rear
panel of the switch with a screwdriver and remove the filler panel.
Step 3: Hold the fastening screws on the front panel of the XFP
interface module, and gently push the XFP interface module in along
the slot guide rail until the XFP interface module is in close contact
with the switch.
(1): Switch
(3): XFP interface module
Figure 3-32 Installing an XFP interface module
Step 4: Tighten the fastening screws with a screwdriver to fix the
XFP interface module.
(3) (3)
(4) (4)
(2) (2)
3-36
Chapter 3 Installing the Switch
(1) (1)
(2): Optional module slot
(4): Push-in direction