H3C S5100-SI series Quick Start Manual page 71

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
Figure 3-36 Front panel of an XENPAK optical module
II. Installation
Step 1: Put on an ESD-preventive wrist strap and verify the
ESD-preventive wrist strap properly grounded. Then take out the
XENPAK optical module from the package.
Step 2: Loosen the two mounting screws on the small cover plate
in the middle on the filler panel with a screwdriver and remove the
small cover plate.
Note:
When installing an XENPAK optical module, you do not need to
remove the whole filler panel. Just remove the small cover plate in the
middle on the filler panel.
Step 3: Hold the fastening screws on the front panel of the
XENPAK optical module, and gently push the XENPAK optical module
in along the slot guide rail until the XENPAK optical module is in close
contact with the switch.
Chapter 3 Installing the Switch
3-40