H3C S5100-SI series Quick Start Manual page 49

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
(1) Outside edge of anchor kit
Figure 3-16 Anchor kit
II. Installation procedure
The wall-mounting procedure is as follows:
1) As shown in Figure 3-17, drill two holes having a diameter of
5 mm (0.2 in.) in the wall on the same horizontal line, with a
distance of 170 mm (6.7 in).
Note:
Drill two holes according to the sizes of anchor kits and screws so that
anchor kits could go into the holes, only the edges could remain
outside the wall, and the screws could be fixed on the wall tightly.
2) Insert anchor kits into the holes and keep only the edges
outside the wall.
(1) (1)
3-18
Chapter 3 Installing the Switch