Connecting Grounding Wire - H3C S5100-SI series Quick Start Manual

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
Figure 3-24 Fix the RPS DC power connector to the chassis
6) Insert the connector into the DC socket directly. Use the
flathead screwdriver to fix the connector with screw 1 and
screw 2 (delivered with the switch), as shown in Figure 3-24.
7) Check whether the PWR LED on the front panel of the
switch is ON. If yes, the power is properly connected.
Caution:
Before powering on the switch, you should properly connect the
grounding wire.
The DC power cord should be less than 3 meters (9.8 ft.) long.

3.5.3 Connecting Grounding Wire

Chapter 3 Installing the Switch
3-27