H3C S5100-SI series Quick Start Manual page 55

Quick Start
H3C S5100-SI/EI Series Ethernet Switches
3) Install the power cord tie for the AC power cord. Insert the
two ends of the power cord tie into the slots at both sides of
the AC power input, and then set the power cord into the
notch of the power cord tie.
(1): Rear panel
(3): AC power cord tie
Figure 3-21 Install AC power cord ties
Note:
The AC power cord tie can prevent the AC power cord from
accidentally falling off.
4) Check whether the PWR LED on the front panel of the
switch is ON. If yes, the power is properly connected.
Chapter 3 Installing the Switch
(1) (1) (2) (2)
(2): Slot of power cord tie
(4): AC power cord
3-24
(3) (3)
(4) (4)