Setting Of Switches - Mitsubishi aj65sbt-rps User Manual

4.5 Setting of switches

The setting of the switches on the AJ65SBT-RPS/RPG module is described
below.
(1) Test switch
This switch is used to set the operating condition of the AJ65SBT-RPS/RPG
module.
In normal operation, set it to OFF.
For detail of the setting, see Section 4.3.
POINT
The setting of the test switch is made valid when the module power is turned
from OFF to ON.
If the setting is changed with the module power ON, perform the above
operation again.
(2) Transmission speed setting switch
This switch is used to set the transmission speed of the AJ65SBT-
RPS/RPG module.
For detail of the setting, see Section 4.3.
POINT
• Set to the same state of setting as set in the master station.
• The setting of the transmission speed setting switches is made valid when
the module power is turned from OFF to ON.
If the setting is changed with the module power ON, perform the above
operation again.
20