Advertisement
HOW TO... REPLACE THE POLY-V BELT - CONTINUED
15. Remove the bolt and keyed washer
that secure the right rocker
assembly to the shaft.
16.
Carefully slide the rocker assembly
off the main shaft.
17. Loosen the shaft collar and slide it
off the main shaft.
18. Remove and save the bolts and
nuts that secure the right side
pillow block bearing to the tower.
19. Slide the pillow block to the right
(but not completely off the main
shaft).
20. Work the old Poly-V belt off the
main shaft.
21. Install new Poly-V belt around the
main shaft and onto the upper
pulley.
22. Slide the pillow block bearing back
to its mounting position.
23. Secure the pillow block bearing
with the bolts and nuts removed
and saved in step 18.
24. Position the Poly-V belt around the
generator pulley.
25. Remove the tension bolt from the
right bracket hole and return it to
the left bracket hole.
26. Tighten the bolt until the
generator assembly returns to its
previously marked position.
27. Install the remaining components
in reverse order using the
hardware removed and saved in
the previous steps.
Elevation 95X-ALLXX-01 Commercial Cross-trainer
"How To..."
65
Advertisement
