Brush And Belt Replacement And Installation - Royal metal upright Owner's Manual

BRUSH AND BELT
REPLACEMENT AND INSTALLATION
(UNPLUG CLEANER)
If you have occasion to remove the revolving brush, either for making adjust-
ments or for replacing belt:
1. Pull knob to remove the "Adjust-0-Rite" belt cover* or rotate the grey rub-
ber nozzle cover* on the front of the nozzle.
2. Lift the belt off the drive shaft with belt lifter tool (reverse directions for
attaching belt shown on page 6).
3.
Remove the metal guard on the bottom of the nozzle. Remove the belt and
brush.
4. To adjust the height of the brush roll or to change the brush, pull the brush
out of the nozzle
.
Slip the belt over the revolving brush before brush is
put into the new position.
Ball bearing brush rolls have color-coded endcaps for easy replacement.
When the brush is new, the color of the endcap must match the color marked
on the inside of the nozzle.
For ALL brush rolls, arrows on brush
roll and nozzle guard must
match (Diagram 1).
Diagram
1
n
5. The belt is then placed over the motor drive shaft as described in "Attach
Belt" on page 6. Place the belt so that the right hand side of the belt is
nearest to you. If the belt dislodges when you turn the unit "on", the belt
is on "backwards". Reverse the belt, twist and place over motor drive
shaft. Replace round "Adjust-0-Rite" plate* or grey rubber nozzle cover*.
CAUTION: Never place any fingers, tools, etc. in nozzle or belt area while the
unit is operating. The "Adjust-0-Rite" plate* or grey rubber nozzle cover* must
be securely installed whenever operating the unit without attachments.
*Feature may differ according to model