Belt Or Brushroll: Removal & Replacement - Royal Vacuum Cleaner Owner's Manual

BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
BELT STYLE
For Belt Style 18 replacements, please call 1-800-321-1134 or visit our website at
18
www.royalvacuums.com to locate a dealer nearest you.
TO REMOVE OLD BELT
1a.
1.
TAB
Turn cleaner over. Base should lay flat and face up. To
remove nozzle guard, remove two (2) screws near rollers
(Diagram 1). Release the nozzle guard by pulling tab
toward the front of the cleaner and rotate/pivot the nozzle
guard up to lift off (Diagram 1a).
TO REPLACE NEW BELT
4.
3.
MOTOR SHAFT
Slip brushroll through belt. Loop belt around motor shaft.
Place belt in area of brushroll
without bristles.
6.
To reassemble the nozzle
guard, align the three (3) tabs
on the front of the nozzle
guard with the slots in the
base. Rotate/pivot the nozzle
guard back into position
making sure that the tab is
fully engaged back by the
rear wheel.
2.
Be sure belt is off motor shaft.
Lift and remove brushroll.
Dispose of old belt.
5.
With new belt in place, pull and
slide brushroll into nozzle making
sure that the brushroll end caps
are in the correct orientation (see
inset). Rotate brushroll manually to
make sure belt is properly
aligned.
7.
Replace the two (2)
screws to secure
nozzle guard.
8