Belt Or Brush Roll Removal And Replacement - Royal Power Pak Owner's Manual

BELT OR BRUSH ROLL
REMOVAL AND REPLACEMENT
NOTE:
Unplug cleaner before changing
belt or brush roll.
1. To remove nozzle guard: turn
power nozzle over and insert
finger into openings near an
arrow as shown (A). Squeeze
clip and pull nozzle guard
toward you.
TO REMOVE BELT
1. Be sure belt is off motor shaft.
2. Lift and remove brush roll (B).
3. Dispose of old belt.
TO REPLACE BELT
1. Loop belt around motor shaft
(c).
2. Slip brush roll through belt.
Place belt on raised area of
brush roll without bristles.
3. Pull brush towards you and
insert into side holder #I and
then #2 (D).
4. Replace nozzle guard. Match
the front tabs to the slots on the
nozzle base. Swing down to
snap hooks. Press firmly on
entire nozzle guard to fit into
place (E).
IMPORTANT: Be sure belt is not
twisted and brush roll rotates
smoothly.