Belt Or Brushroll: Removal & Replacement - Royal Vacuum Cleaner Owner's Manual

BELT OR BRUSHROLL: REMOVAL & REPLACEMENT**
**ONLY FOR MODELS WITH ROTATING BRUSHROLL
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT.
BELT STYLE
For Belt Style 7 replacements, please call 1-800-321-1134 or visit our website at
7
www.royalvacuums.com to locate a dealer nearest you.
TO REMOVE BELT
2.
1.
Flip cleaner on its side to To remove belt cover, use
expose nozzle base. Phillips screwdriver to remove
the two screws. Arrows show
location of screws.
TO REPLACE BELT OR BRUSHROLL
5.
4.
Grasp brushroll with one Remove belt. Dispose of old
hand, using other hand to belt.
keep tension on belt when
removing. Lift up when
pulling out.
7. 7a.
With belt in place, pull and
slide brush roll into nozzle,
making sure that
brushroll end caps are in the
correct orientation (Diagram
7a). IMPORTANT: ROTATE
BRUSHROLL MANUALLY TO
MAKE SURE BELT IS NOT
TWISTED OR PINCHED.
3.
Grasp belt cover near brushroll
and lift out.
6.
Place belt on motor shaft,
then slip brushroll through
belt. Place belt in area of
brushroll without bristles.
8.
Replace belt cover by
inserting end furthest
the from brushroll first.
Then place front of belt
cover into position.
Secure by replacing
the two screws.
12