Release The Cord; Tilt Nozzle; Lower Handle - Royal metal upright Owner's Manual

2. Five Position Height Settings: Adjust carpet settings for floor surface to
be cleaned. Set the nozzle at five different carpet heights with the touch of
your toe. The illustrations show the height adjustor in the lowest and highest
positions. The setting should be low enough for effective cleaning, yet high
enough that the cleaner is not difficult to push.
Note: If cleaner is difficult to push, adjust to a higher carpet setting height.
SETTINGS FOR
LOW PILE
RELEASE THE CORD
On models equipped with a quick cord release, simply
push the quick release cord hook forward or backward
until it is upside down. The cord will slide off easily.
Return quick release cord hook to its upright position
so it is ready to store the cord when you complete your
cleaning tasks.
TILT NOZZLE
To clean throw rugs and carpets with fringed edges, push handle down below
normal operating position thereby raising the nozzle (so fringe or binding will
not catch). Throw rugs should be cleaned by working from the center toward
and over the fringe, tilting the nozzle upward and over the edge of the carpet.
LOWER HANDLE
To clean carpeted stairways and under low furniture and beds, start with han-
dle back in tilting position. Then lift handle lock lever (located where handle
meets motor housing) with your toe and lower handle to floor. For stairways,
depress handle lock lever so cleaner can be held in a horizontal position. To
raise handle, release handle lock lever.