Easy To Assemble; Attach The Belt; Assembly The Handle - Royal metal upright Owner's Manual

EASY TO ASSEMBLE
Note: Do not connect cleaner to electrical outlet until it is assembled.
Assemble the Handle
(Diagram I )
1. Slide the upper and lower handle
sections together, aligning the
square or round holes on both
handle sections.
2. From the literature pack, get the
square neck curved head bolt,
curved washer, and 711 6" nut.
3. lnsert square neck curved head
bolt through square aligned hole opening, until curved head is flush
with handle. WARNINGDO NOT FORCE HANDLE BOLT. MAY SEVER
CORD, COULD CREATE SHOCK.
4. Place curved washer over threaded end of bolt and tighten 7116"nut with
appropriate tool (tool not included).
All except models below Remove wing nut and bolt from fork completely.
lnsert handle and power cord into the fork. Tighten.
Models with a pigtail: Loosen the large wing nut on the handle fork located on
the motor unit. Inset the handle into the fork and tighten the large wing nut.
5. Connect the cords at the handle bottom and the motor unit. Wind the extra-
long electrical cord over the cord hooks when cleaner is not being used. The
electrical cord is ~ermanentlv attached to the upper part of the handle and a
short connector plug is at theother end.
Check to be sure the belt is in place.
If not, follow these easy steps:
Attach the Belt
1. Remove "Adjust-0-Rite" belt cover*
or rotate the grey rubber nozzle
cover* from front of cleaner.
(Diagram 1)
2. Insert belt lifter tool through belt
loop, being sure to hook belt around
the lip of the belt lifter tool from the
left (Diagram 2). Using the tool as a
pry bar, slip the belt onto the motor
shaft until the belt lifter base meets
the shaft. Gently turn the tool to the
right (clockwise) to insure proper
belt placement. Remove tool.
3. The front of the belt will be to your
right when installed properly
(Diagram
3).
Snap "Adjust-0-Rite"
belt cover* or rotate the grey rubber
nozzle cover* over the belt access
opening.
*Feature may differ according to model.