Programming Key; 12V Parallel Coiner Kit - Saeco D.A. COMBISNACK Use And Maintenance

14 - PROGRAMMING KEY

The programming key allows the set data transfer in the following
programming menu entries:
- PRICE MANAGEMENT. All data can be transferred;
- TIME MANAGEMENT. All data can be transferred;
- PAYMENT SYSTEMS. All data can be transferred;
- SYSTEM MANAGEMENT. All data can be transferred,
expect the PASSWORD.
To properly use the programming key, do as follows:
- open the vending machine front door;
- insert the programming key into the connector (ref. 6, fig. 1).
- switch on the vending machine.
The copy key presence enables the following menu display:
DATA TRANSFER DATA TRANSFER
COPY VMC - > - > - > - > KEY
- >
DATA TRANSFER
DATA TRANSFER
COPY KEY - > - > - > VMC - >
- >
This is only displayed if the data on
the key comes from a vending
machine of the same type.
The allowable operations are the following:
Display message
copy of vending
DATA TRANSFER
machine data on the
COPY VMC ==> KEY
key
DATA TRANSFER copy of key data on
the vending machine
COPY KEY ==> VMC
Any possible data transfer error is shown on the display through
the "TRANSFER KEY - ERROR IN KEY DATA" message. Should
this message appear, repeat the transfer procedure, and if the
error is not removed, please contact the AUTHORIZED
CUSTOMER SERVICE CENTER.
DATA TRANSFER
0..50..99% DATA TRANSFERRED
DATA TRANSFER
0..50..99% DATA TRANSFERRED
Operation Notes
This operation is
always possible.
This operation is
only possible if the
data on the key
comes from a
vending machine
of the same type.

15 - 12V PARALLEL COINER KIT

Allows to use 12Vdc parallel coin selectors.
Assembly kit (fig. 95)
a. 16-pole flat cable
b. 3 adhesive spacers
c. 10-pole flat cable
d. Interface card
a
b
Installation
- Open the upper door and slide the keypad carter up. Insert
the 3 adhesive spacers (fig. 95, b) into the special holes of the
interface card (fig. 95, d) and remove their protective paper
(fig. 96). Fasten the card in the most convenient position for
the user.
- Insert the 16-pole flat cable (fig. 95, a) into the special seats
of the CPU card and interface card (see fig. 97, e).
- Insert the 10-pole flat cable (fig. 95, c) into the interface card
seat (see fig. 97, f), then connect the other end of the 10-pole
flat cable to the 12V parallel selector.
English
d
fig. 95
fig.96
e
f
fig.97 fi fig. g.97 g. g.97 97 97
Es Es Es Espr Es Es Es Es pr pr pr pr pres pr es es esso es so It Ital alia ia PT PT PT PT PTY PT PTY PT Y Y
www.espressoitalia.com.au
Freecall 1300 660 976
c
LTD LT LTD LT LT LTD D D
25 25 25