Saeco D.A. COMBISNACK Use And Maintenance page 9

230V 50Hz
FAN
Power supply wirings inlet solenoid valve
INLET SOLENOID VALVE
- Reassemble the machine rear panel taking care to reconnect
the earth cable.
- Open the V.M. lower door.
- Tighten the spring (ref. b, fig. 9) in the position shown in fig. 29
by using the two screws and two washers 4,3x12 (ref. h, fig. 9).
- Replace the pipe fastened to the drain channel (fig. 21) with
the drain tube (ref. p, fig.9). Remove the cap (ref. m, fig. 9)
from the tank. Insert the other end of the pipe in the discharge
fluid tank (fig. 22). Make sure that the other tank holes are
properly capped.
fig. 21
Important
Before removing the tank to empty it, close the pipe hole
using the relevant cap (ref. m, fig. 9). This will help preventing
any liquid spillage due to the surge effect.
Power supply wirings
PINK
PINK
PINK
DARK BLUE
DARK BLUE
DARK BLUE
DARK BLUE BLUE
RED RED
24 V D.C.
fig. 20
fig. 22
PINK
fan motor
PUMP 1
DARK BLUE
- Insert the pipe (ref. g, fig. 23) in the perforated cap of the
drinking water tank.
- Fill the drinking water tank.
- Fit the cap on the tank. Place the tank inside the V.M. (fig. 24)
by sliding the pipe inside the tank itself. Close the hole (ref. v,
fig. 23) by means of the cap (ref. n, fig. 9).
- - - Close the vending machine lower door. Close the vending machine lower door. Close the vending machine lower door.
RELAY
RED
PINK
DARK BLUE
BLUE
g
fig. 23
fig. 24
Espresso Italia PTY LTD
www.espressoitalia.com.au
Freecall 1300 660 976
English
fig. 19
v
9 9 9