Pulse Counter Kit - Saeco D.A. COMBISNACK Use And Maintenance

English
6 -

PULSE COUNTER KIT

The vending machine can be fitted with an electromechanical
pulse counter (24V DC) which will count the number of coffees or
the total beverages brewed by the machine.
Assembly kit (fig. 35)
a. 1 pulse counter with support
b. 2 screws
a
b
Installation
- Open the upper door and fasten the pulse counter (ref. a, fig.
35) to it (fig. 36) by means of the two screws (ref. b, fig. 35).
- Couple the pulse counter wiring with the "CN14" connector
of the board (fig. 37).
12
To enable the counting of coffees or beverages brewed, access
the machine programming menu and set "COFFEE" or
"BEVERAGES" in the "PULSE COUNTER" menu (fig. 38).
In order to properly carry out this operation, disable the safety
device and press key 1 (fig. 33) to access the programming
menu.
If no password has been assigned you enter the programming
menu directly.
If vending machine was assigned a password to enable the
programming menu, "PASSWORD 0000" will appear on
display with a flashing cursor on the first digit.
Now digit the password using UP and DOWN keys. Confirm
the entered digit by means of ENTER key.
To exit the programming menu and return to the normal operation
of the vending machine:
- press key 1 again;
fig. 35
- remove the key from the safety switch to turn off the vending
machine;
- close the door and wait for the self-configuration process to
end.
SISTEM MANAGEMENT
fig. 36
fig. 37
Important
VM CODE
0000
STOP
MIN. TEMPERATURE
098
MAX. TEMPERATURE
108
COLD TEMPERATURE
6
COMPRESSOR
YES
DRAINAGE TANK
NO
MECH. COUNTER
COFFEE
Espresso Espresso
www.espressoitalia.com.au
Freecall 1300 660 976
Entries selectable
only with complete
menus
MECH. COUNTER
COFFEE
MECH. COUNTER
BEVERAGES
fig. 38 fig. 38 fig. 38 fig. 38 fig. 38
Italia PTY LTD