Independent Tank Kit - Saeco D.A. COMBISNACK Use And Maintenance

4 -

INDEPENDENT TANK KIT

This kit allows the vending machine to be supplied by means of
an internal tank instead of by the water network. To do this, it is
necessary to use the tank inside the machine as drinking water
hopper. If the machine has not been started for the first time, and
the tank has already been used as discharge fluid tank, it shall be
replaced with a new one.
Assembly kit (fig. 9)
a. 1 discharge fluid tank with cap
b. 1 spring for tank
c. 1 pump with supports and pipe fitting
d. 1 pump wiring harness
e. 1 pump feeding wiring
f. 1 cap for spout
g. 1 water inlet pipe
h. 4 screws and washers (two of them measure 4,3x12 and the
other two 4,3x16)
i. 1 perforated cap
m. 1 cap for spout
n. 1 KAPSTO GPN 350 dia 30 cap
p. 1 PVC drain tube
r. 1 relay with support plate
a
b
c
d
e
Installation
- Remove the machine rear panel (fig. 10) by untightening the
screws and disconnecting the ground wiring placed on the
machine.
f
i
m
n
p
g
r
h
fig. 9
fig. 10
- Open the upper door and take out the retaining spring from
the left hand pipe (fig. 11).
- Disconnect the two pipes from the water inlet solenoid valve
(fig. 12)
s
t
- Apply the pipe retaining spring (see fig. 11) on the silicone
pipe (ref. t, fig. 12) fitted on "T" and previously removed from
the inlet solenoid valve (fig. 13).
English
fig. 11
fig. 12
fig. 13
Espr Es Es Es Es Es Es Es Es Es Es Espresso Es pr pres pr pr es es esso so It Italia Ital It alia ia ia ia ia ia PTY PTY PTY PT Y LTD
www.espressoitalia.com.au
Freecall 1300 660 976
LTD LT LT D
7 7 7