Float Kit - Saeco D.A. COMBISNACK Use And Maintenance

Vending machine accessories and payment systems
Hide thumbs Also See for D.A. COMBISNACK:
Table of Contents

Advertisement

English
5 -

FLOAT KIT

It allows the display to read the discharge fluid maximum level. In
this condition, no hot beverage is available and the display will
read "ERROR 09".
The float can be installed in different positions according to whether
the machine is connected to a water network (22 L tank) or uses
an independent tank (7L tank).
Assembly kit (fig. 25)
a.
1 basket set for discharge fluid level
b.
2 screws
c.
1 reed wiring
Important
When assembling the lower level sensor (fig. 26) disconnect
the higher sensor (fig. 30). The drain level control system
doesn't work if two sensors are connected.
Installation
-
Open the front lower door.
-
If it is applied on the independent tank version, it is necessary
to remove the 7 L tank (ref. g, fig. 28) and to assemble the
reed wiring (ref. c, fig. 25) by means of the two screws (ref.
b, fig. 25) according to the position shown in the figure (ref.
e, fig. 26).
10
a
b
c
fig. 25
d
e
fig. 26
-
Slide the other end of the reed
wiring inside the hole (ref. d,
fig. 26) and couple it to the
connector (ref. f, fig. 27).
-
Remove the tank cap (fig. 28) and replace it with the discharge
level basket set (fig. 29).
g
fig. 28
-
Reinstall the tank.
-
If it is applied to the water network version, it is necessary to
remove the 22L tank (ref. i, fig. 31) and to fit the reed wiring
(ref. c, fig. 25) by means of the two screws (ref. b, fig. 25)
on the square (ref. h, fig. 30). Then, couple the other end to
the connector (fig. 30).
-
Remove the tank cap (fig. 31) and replace it with the discharge
level basket set (fig. 32).
i
fig. 31
-
Reinstall the tank.
f
fig. 27
fig. 29
h
fig. 30
fig. 32
Espresso Italia PTY LTD
www.espressoitalia.com.au
Freecall 1300 660 976

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents