Payment System Feeder Kit - Saeco D.A. COMBISNACK Use And Maintenance

3 - PAYMENT SYSTEM
FEEDER KIT
This kit provides all the necessary power supply for the proper
operation of the payment systems connected to the CPU card of
Combisnack vending machine, which have a mains voltage of
+ 12 Vdc (parallel banknote readers) or + 6 Vdc (1432.0xx
and 1471.0xx models saeco card).
Assembly kit (fig. 3)
a. 1 feeder outlet wiring harness - CPU card
b. 4 screws and spacers
c. 1 feeder inlet wiring harness - CPU card
d. 1 +6Vdc / +12Vdc feeder board
a
b
Installation
- Open the upper door and fasten (fig. 4) the payment system
power supply board (ref. d, fig. 3) to the same door by using
the four screws and spacers (ref. b, fig. 3).
- Connect the wiring harness (ref. a, fig. 3) to the payment
system power supply board as well as to the CPU card (fig.
5). See instructions on harness to carry out the connection.
c
d
- Unplug the four-pin connector from the CPU card (fig. 6).
fig. 3
- Connect the two-pin connector (ref. c, fig. 3) to the payment
system power supply board. Connect the 2 contacts of the
other end to the 2 free slots of the 4-pin connector that was
previously unplugged from the CPU card (fig. 7).
fig. 4
English
fig. 5
fig. 6
fig. 7 fi fig. g. g. g.
Es Espr pres esso es so so so so so so so It Italia ia ia PT PTY PT PTY PT PT PT PT Y Y
www.espressoitalia.com.au
Freecall 1300 660 976
7 7
LTD LT LTD LT LT LTD D D
5 5 5