Table of Contents
Advertisement
3.
Release the clips (3), and then remove the power connector cable (4).
Reverse this procedure to install the power connector cable and bracket.
Fan
Description
Fan
Before removing the Fan, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the top cover from the base enclosure (see
7.
Remove the WLAN module (see
8.
Remove the system board (see
Remove the fan:
1.
Turn the system board upside down.
2.
Disconnect the fan cable from the system board, and then remove the piece of tape that secures the fan
to the heat sink (1).
58
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
30),
Optical drive on page
WLAN module on page
System board on page
Spare part number
765788-001
31).
Base enclosure on page
34).
44).
51).
Advertisement
Table of Contents
