Table of Contents
Advertisement
1.
Disconnect the #1 and #2 WLAN antenna cables from the WLAN module (1) if you have not already done
so to remove the display panel.
NOTE:
The WLAN module may have two screws depending on the model.
NOTE:
The #1 WLAN antenna cable is connected to the WLAN module #1 main terminal. The #2 WLAN
antenna cable is connected to the WLAN module #2 auxiliary terminal.
2.
Remove the Phillips PM screw(s) (2) that secure the WLAN module to the system board. (The WLAN
module tilts up.)
3.
Remove the WLAN module by pulling the module away from the slot at an angle (3).
NOTE:
If the WLAN antennas are not connected to the terminals on the WLAN module, the protective
sleeves must be installed on the antenna connectors, as shown in the following illustration.
Component replacement procedures
45
Advertisement
Table of Contents
