Table of Contents
Advertisement
Before removing the optical drive connector board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the base enclosure and top cover (see
Remove the optical drive connector board:
▲
Disconnect the cable from the ZIF connector (1), and then disconnect the optical drive connector (2)
from the tabs to remove it.
Reverse this procedure to install the optical drive connector board.
48
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
30).
Optical drive on page
Base enclosure on page
31).
34).
Advertisement
Table of Contents
