Table of Contents
Advertisement
3.
Remove the power connector cover by removing the screw(s) (1) and lifting the cover (2).
NOTE:
The power connector cover has two screws, however, the screw on the left is removed during
the base enclosure and top cover removal process.
NOTE:
You will remove the power connector after you have removed the system board. This
procedure is to remove the power connector cover if did not remove it when removing the display panel.
4.
Remove the six Phillips screws (1).
5.
Lift the system board (2), and then remove the system board (3) by sliding it up and to the right at
an angle.
Reverse this procedure to install the system board.
Component replacement procedures
53
Advertisement
Table of Contents
